1. Home
Send to a Friend via Email

Discuss in my forum

Make a Plastic Bottle Bird Feeder

Instructions and Tips

By

Plastic Bottles

Recycle plastic bottles by making bird feeders.

Klearchos Kapoutsis

Making a plastic bottle bird feeder is a fast, easy project and a great way to recycle for the birds. These simple feeders are also perfectly functional and can help backyard birders feed more birds without purchasing expensive feeders.

Materials

To make a plastic bottle bird feeder, you will need:

  • Plastic bottle – 2 liter bottles are most common, but any size will work
  • Perches – thin dowels, unsharpened pencils, chopsticks, twigs, etc.; ideally 8-10 inches long
  • Metal screw hook
  • Glue
  • Awl or other tool for making small holes – knife, nail, etc.

Note: While this project is easy enough for children, proper supervision should always be present.

Steps

  1. Clean and dry the bottle thoroughly, removing any labels. Allow the bottle to air dry for several hours or overnight if possible to ensure no moisture remains inside that could potentially cause seed to spoil.

  2. Screw the hook in the center of the cap, making sure it is firm and tight. If necessary, use the awl or nail to start the hole to make screwing the hook in easier. After the hook is fully inserted, seal both sides with a drop of glue – this will provide extra security and keep moisture out of the feeder.

  3. Cut holes large enough to fit the perches 1.5 inches from the bottom of the bottle. The perches should fit snugly into the holes and extend completely across the bottle and out the matching hole on the opposite side. When inserting the perches, balance the length of the perch on each end to allow birds to feed comfortably.

  4. If desired, add additional perches higher on the bottle. Each perch should be 2-3 inches higher than the last, and rotate where the perches are on the bottle to take advantage of the most space for feeding birds. The highest perch should be 3-4 inches below the cap.

  5. Cut feeding ports 1-2 inches above each perch. Ports should be 1/8-1/4 of an inch wide depending on the seed type; use larger holes for mixed seed or sunflower seeds and smaller holes for Nyjer or millet. Oval-shaped holes taller than they are wide will be easier for birds to feed from.

  6. Fill the feeder slowly with the desired seed. If the feeding ports are too big, placing a piece of clear tape snuggly over them and recutting smaller holes in the tape can fix the problem.

  7. Hang the feeder outside and wait for birds to discover it! Feeders can be hung from small branches or hooks, or string can be looped around the cap hook to hang the feeders in other areas.

Tips for Plastic Bottle Bird Feeders

To keep your new bird feeder at its best for the birds…

A plastic bottle bird feeder is easy to make and a joy to watch; experiment with making different feeders out of different bottles to quickly and cheaply add to your backyard buffet.

Photo – Plastic Bottles © Klearchos Kapoutsis

Fill Your Plastic Bottle Bird Feeder With These Choice Foods for Birds:
You May See These Seed-Eating Birds at Your Plastic Bottle Bird Feeder:

©2014 About.com. All rights reserved.